Call us at 775-419-3476. No need to select a department, dial an extension or tell a machine why you’re calling. Call us, and we’ll help you. It’s that easy.
$5,300.00 – $24,750.00
Coriolis flow meters (also referred to as Coriolis mass flow controllers) are very accurate flow meters designed to measure the flow rate of liquids, slurries, & oils. Our flow meters ship from stock (usually within 48hrs) and are configured for you.
A Coriolis flow meter contains a tube which is energized by a fixed vibration. When a fluid (gas or liquid) passes through this tube the mass flow momentum will cause a change in the tube vibration, the tube will twist resulting in a phase shift. This phase shift can be measured & a linear output derived proportional to flow.
Our EASY to use CORIOLIS Mass Flow Meters are in stock at prices that beat our competition.
Features LARGE OLED display, shows the Instantaneous (Instant) Flow Rate, Total Flow, Temperature, and Density in user selectable units.
Click to enjoy a LARGE size of the menu in PDF shown below.
Notes about ZERO Calibration on Coriolis meters.
NOTE: It is critical to invoke the zero point calibration after installation.
Every Coriolis Meter must be zeroed in the final installation point with the fluid that will be measured.
Make sure the meter has warmed up for at least 15 minutes before invoking the zero function. Make sure the measuring tube is fully filled with liquid. Turn off the stop valves, make sure the liquid is in a stationary state, and invoke calibrate the zero point as shown below. The zero function is in process when the display indicates "Zeroing, please wait for 30 s" for about 30 seconds and then reverts to the zero uS display mode. This function is CRITICAL to allow the meter to determine the resonant frequency of the measuring tube is to determine the density of the fluid within it. This step cannot be skipped. Once this step is complete you will want to confirm the measured density is accurate.
Coriolis mass flow meters directly measure the mass flow and the density of the fluid. The volume flow rate is calculated by mass flow divided by density. If the density measured at the zero point is not accurate, then the flow rates will be affected as well.
We explain what is shown in the manual below for ease of access.
TFM-CDLS Cloud Data Logger System
Low Cost Cloud Data Logging System $500.00The TFM CDLS, Tactical Flow Cloud Data Logging System, uses either the analog outputs &/or the Modbus RTU communication from all Tactical Flow Meters or other devices using Modbus RTU devices to send the data to the cloud for data monitoring & control. ... Data is saved on the Cloud for 6 months.
> view
1/2" to 12" MAG Flow Meter
Flow meters for liquids. Accuracy of ± 0.5% $2,112.00 – $10,450.00Electromagnetic flow meters, also called mag meters or magnetic meters, are volumetric flow meters which do not have any moving parts to wear, reducing the need for maintenance or replacement. Accuracy over a wide flow range can be as good as ± 0.5% of flow rate or better.
> view
Ultrasonic Liquid Flow Meter with Thermal Energy/BTU Capability
Ultrasonic flowmeters use sound waves to determine the velocity of a fluid flowing in a pipe $2,400.00 – $2,475.00Ultrasonic flowmeters use sound waves to determine the velocity of a fluid flowing in a pipe. At no flow conditions, the frequencies of an ultrasonic wave transmitted into a pipe & its reflections from the fluid are the same.
> view
