If the front side of the transmitter display is not visible you may rotate the transmitter at an angle of 90° or 180°, so that the display is facing the user. To do this, unscrew the four bolts (1) (see Figure 2.10). Then turn the transmitter (2) by 90° or 180° in the desired direction and tighten those 4 bolts to ensure sealing. Be very careful with the wiring during the process. Do not turn more than 180 Degrees.
Figure 2.10 – Rotation of the transmitter
CAUTION! |
To avoid excessive twisting of wires inside the coriolis mass flow controller do not turn the transmitter at an angle over 180° from its initial position. |